NORAUTO ENDURO Mode D'emploi page 118

During Battery Charging
Connect and setup the unit properly to start the charging.
If the Fault Icon lights up, unplug the charger from main power, and connect clamps or terminal
rings by respecting the polarity.
If the unit is connected to mains socket but the clamps/terminal rings do not connect to the battery, the
LCD screen will display 6V Icon
CHARGING
1. After connect and set-up the unit, the LCD screen will display
Icon, and the empty battery icon
automatically.
2. To indicate the unit is in charging mode, the charging current X.X
displays alternatively for every 3 seconds. And the LCD screen displays the
Icon, XX.X and the "+" Icon.
Hr
3. When the battery is completely charged, the charger will automatically go into Float Charge Mode,
and the LCD screen will display the
Icon as well.
* In this mode, the charger monitors the battery voltage and charges as necessary to assure the
battery maintains full capacity.
* The charger remains in Float Charge Mode as long as the charger is connected to the battery and
is plugged into a functioning AC mains socket.
4. Press any buttons during charging process, the unit will go to the corresponding mode.
ATTENTION:
If 6V charging mode selected but the battery is 12V and internal short circuit, it keeps charging but
the battery will not be charged fully. If it is a good 12V battery, the charging process will be terminated.
If 12V charging mode selected but the battery is 6V, after several minutes, the LCD screen will
display following:
The empty battery Icon
flash.
IMPORTANT
or 12V Icon
as well. After few seconds, the charging process will start
or or
lights solid, the Err Icon, the Fault Icon
118
or Icon.
Icon or
and the battery voltage XX.X
A
Icon, the empty battery icon
and the 12V Icon
Icon or
V
, and the
will