NORAUTO ENDURO Mode D'emploi page 116

Connecting the charger and charge the Battery with the Battery Clamps
IMPORTANT: Before start connecting, unplug the battery Charger AC cord from the AC
outlet. Disconnect the battery clamps from the unit at output cord connector.
The charger's battery clamps are color-coded (RED-POSITIVE and BLACK-NEGATIVE).
1
1 - Connect the RED POSITIVE clamp to the
POSITIVE post of the battery.
2 - Connect the BLACK NEGATIVE clamp to the
NEGATIVE post of the battery.
2
Connect the battery clamp connector to the unit
connector, as far away from the battery as possible.
3
Plug the unit onto the power socket.
* The charger remains in Float Charge Mode as
long as the charger is connected to the battery
and is plugged into a functioning AC mains
socket.
To Start the Charging
If 6V or 12V Lead-acid battery,
Press STANDARD, to select the charging voltage
mode (6V or 12V) according to the battery voltage.
If 12V Lithium battery, Press LIUTHIUM.
Attention: Please wait for few seconds to toggle
the 6V or 12V or Lithium battery charging mode by
pressing the button.
CAUTION: Lithium charging mode is only for
12V lithium battery. DO NOT connect to a 6V or
24V DC battery system or other type batteries.
116
4