NORAUTO ENDURO Mode D'emploi page 117

Connecting the charger and charging the Battery with the Terminal Rings
IMPORTANT: Before start connecting, Unplug the battery charger AC cord from the
AC outlet. Disconnect the crimped terminal rings from the unit at output cord connector.
The charger's crimped terminal rings are color-coded (RED-POSITIVE and
BLACK-NEGATIVE). These rings connect directly to the corresponding connectors
on the battery posts.
NUT
CONNECTOR
1. Remove the nuts from the bolts of the battery
post's connectors.
2. Position the red terminal ring on the bolt of the
positive battery post connector.
3. Position the black terminal ring on the negative
battery post connector; then replace the nuts.
Connect the battery eyelet connector to the unit
connector, as far away from the battery as possible.
1
TERMINAL
RING
BOLT
2
117
3
Plug the unit to the power socket.
4
* The charger remains in Float Charge Mode
as long as the charger is connected to the
battery and is plugged into a functioning AC
mains socket.
To Start the Charging
If 6V or 12V Lead-acid battery,
Press STANDARD, to select the charging voltage
mode (6V or 12V) according to the battery voltage.
If 12V Lithium battery, Press LIUTHIUM.
Attention: Please wait for few seconds to toggle
the 6V or 12V or Lithium battery charging mode by
pressing the button.
CAUTION: : Lithium charging mode is only for
12V lithium battery. DO NOT connect to a 6V or
24V DC battery system or other type batteries.