Publicité
Les langues disponibles
Les langues disponibles
Horizontal and vertical levelling
2
Open the transport restraint and switch on the laser (button 1). The
laser cross will appear. Now horizontal and/or vertical levelling work
can be done.
The Out-Of-Level function must be activated in order
to do horizontal and vertical levelling. It is activated by
releasing the transport restraint. The Out-Of-Level function
!
signals when the device is set up outside of its 4° automatic
levelling range. If this is the case, the ON/OFF button will
illuminate and the lasers will shut off. Place the device on
a surface that is more level.
Slope mode
3
Lock the transport restraint and switch on the laser (button 1). Now
slopes can be laid out. IMPORTANT: This mode cannot be used to
perform horizontal or vertical levelling because the laser lines are no
longer automatically aligned.
EU directives and disposal
4
This device complies with all necessary standards for the
free movement of goods within the EU.
This product is an electric device and must be collected
separately for disposal according to the European
Directive on waste electrical and electronic equipment.
!
Regularly check the calibration before use, after
transport and after extended periods of storage.
Technical data
Self-levelling range
Precision
Operating range (depending
on room illumination)
Laser wavelength
Laser class / line laser output power
Power supply / operating time
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. battery)
Subject to technical alterations 02.2010. Further safety and
supplementary notices at: www.laserliner.com/info
08
GB
± 4°
± 5 mm / 10 m
20 m
635 nm
2 / < 1 mW
1 x 1.5 V alkaline cell
(type AA, LR6) / 5 hr.
0°C ... +50°C
-10°C ... + 70°C
35 x 153 x 36 mm
0,13 kg
Publicité
