Publicité
The Connection Cord:
WORKSHEET A
Connection cords are typically 20 to 60 feet long, with a maximum
Generator Size:
recommended length of 60 feet for a 50-amp circuit. To determine the correct
(Watts)
cord length, follow these easy steps:
B
C
Load
Start
STEP 1. Select a location for your generator when it is being used with
Factor
GenerLink™. Consult your generator manufacturers owner's manual for
instructions on the acceptable placement of your generator.
STEP 2. Measure the length of the cord you will need by calculating the
distance from the installed GenerLink™ to your generator, including the
vertical distance from the electric meter to the ground.
The length of the power cord should always be as close as possible to the actual
measured distance from the electric meter in order to maximize your generator's
power quality. Additionally, the power cord must be fully unrolled during use.
NOTE:
The GenerLok™ power cord is the only power cord approved for use
with GenerLink™. The GenerLok™ connector can only be used with
GenerLink™. It is not compatible for use with any other electric
appliance/device.
Lights
Wattage
8
16
All manuals and user guides at all-guides.com
D
E
X
Run Watts = Load
Watts
X
=
X
=
X
=
X
=
X
=
=
X
F
Number
X
=
60
X
=
100
X
=
150
Total:
T
echnical Fact Sheet
T
Surge Protection (Optional MA23/24-S)
echnical Fact Sheet
Surge Protection (Optional MA23/24-S)
GenerLink™ Specifications and Technical Information
To determine if your GenerLink™ unit is equipped with surge protection,
check the product label on the collar of the device for the model number
Physical:
MA23/24-S.
Diameter:
Depth:
What are Surges?
Weight w/o surge:
A surge is a sudden, unpredictable, powerful increase in voltage that can
Weight with surge:
damage or destroy household appliances and electronic equipment. Surge
Socket Style:
damage can happen all at once in cases of high voltage surges or over a period
of time when lower voltage surges are experienced consistently.
Electrical:
Source Compatibility:
How to Protect Your Home and Appliances from Voltage Surges.
Withstand Current:
Surges can occur on power, cable TV, telephone and data lines. They are
caused by many sources: lightning, the switching of utility equipment on the
electric grid, electrical accidents, heavy motor or heavy loads from a nearby
Generator Input:
industry or locally, by microwave ovens, laser printers and copiers, air
conditioner compressor motors and even lights being turned on and off.
Connection:
GenerLink™ with Surge Protection:
■
Operational:
Protects household equipment including appliances and hard-wired systems
■
Transfer Type:
not protected by power strips. Plus, it provides enhanced protection for
Transfer Delay:
household electronics.
Life Cycle:
Provides protection beyond typical point-of-use power strips and plug-ins.
■
Temperature Range:
Produces an audible alarm when the devices requires service.
■
Protects against spikes up to 100,000 amps on the electric system.
■
Features:
Provides a white goods warranty of $1,000/appliance and/or $10,000/house.
■
Generator Input Protection:
Is meter-based and will provide the first line of defense at your home's
■
service entrance and for your wired appliances from voltage surges. (Refer
to the Terms and Conditions for service instructions)
Utility Input Protection:
To protect sensitive plugged-in appliances and equipment, you should combine
GenerLink™ (with surge protection) with outlet-strip/ plug-in surge protectors.
G
Load Protection:
Purchase high quality plug-in strips to protect sensitive equipment and
appliances such as your computer and audio/visual equipment. Always consult
your specific appliance owner's manual before installing plug-in surge strips.
Status Indication:
Listings:
†
3 hours at 25°C/ 77°F ambient
*When protected by max 200 A circuit breaker in series with 100 A branch circuit breaker
6 ¹�₂ in.
5 ¹�₄ in.
5 ¹�₂ lbs
5 ³�₄ lbs
Ring or Ring-less, 200 Amp, 4 jaw
200 Ampere Service or Less
14,000 Amperes rms symmetrical at .5 pf,
240 Volts, 60 Hz 6000 Amperes for 6 cycles
at .7 - .8 pf, 240 Volts, 60 Hz
10kW Continuous
†
, 120/240 Volt
7.2kW Continuous for MA-23
Proprietary GenerLok™ QuickConnect
Power Cord
Break-Before-Make
2-3 Seconds
300,000 Operations
-30°C to 60°C External Ambient
Generator Input Voltage ≥ 200 Volts
Supplemental Overcurrent ≤ 40 A
Utility Input Voltage ≥ 180 Volts
Over-Temperature Trip ≥ 105°C
Integrated Whole-House Surge Protection
Model MA 23/24-S Only (Optional)
Type 1 - 75kA per phase
Long-life LED indicators show utility power
availability and/or fault presence
UL 1008M - Meter socket transfer switch
17
9
Publicité
