Flex CHE 5-45 SDS-max Notice D'instruction D'origine page 17

CHE 5–45 SDS-max
Attaching the depth stop
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
 Loosen knurled screw on the auxiliary
handle.
 Push in depth stop.
 Set depth stop to the required drilling
depth.
 Retighten knurled screw.
Speed and impact rate preselection
 Set thumb wheel to the required value.
Setting
Speed (min
1 235
2 265
3 320
4 380
5 440
6 500
Impact number
-1
)
-1
(min )
1350
1520
1840
2180
2530
2870
Setting operating mode
`^rqflk>=
aç=åçí=ÅÜ~åÖÉ=çéÉê~íáåÖ=ãçÇÉ=ìåíáä=íÜÉ=
ÉäÉÅíêáÅ=éçïÉê=íççä=áë=~í=~=ëí~åÇëíáääK
Setting rotary knob to the required operating
mode:
Hammer drilling
Setting the chisel position
(see below)
Chiselling
Setting the chisel position
The chisel can be adjusted in 16 positions
(moved 22.5° in each case).
 Move rotary knob for operating
mode to the
 Turn rotary ring for chisel setting until
the chisel is at the required angle.
 Move rotary knob for operating mode
to the symbol.
symbol.
17