Frigelux RF190A Serie Manuel D'instructions page 31


Installation
Let your device breathe. Heat is released from the walls so it is important to leave a circulation of air
around your device.
Turn off your appliance

If the unit is not likely to operate for a long period of time:

Remove all food from your appliance from the refrigerator.

Switch off the appliance by setting the thermostat to position 0.

Unplug the appliance.

Clean it thoroughly.

Keep the door open to prevent odors from rising.
Energy saving tips

The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.

Let hot foods cool to room temperature before placing in the refrigerator. Overloading the
refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.

Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.

Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the refrigerator less efficient.

Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Changing the light bulb
Light bulb data: 220-240 V, max. 15 W
To switch off the appliance, set the temperature regulator to position "0".

Unplug the mains plug.

To change the light bulb, undo the screw.

Press the light bulb cover as shown and slide it backwards.

Change the defective light bulb.

Refit the light bulb cover and the screw.

Put the refrigerator back into operation.
Door reversal instructions
Your refrigerator is built with a reversible door. You have the choice of either opening it from the left or the
right side. In order to reverse the opening direction of your door, please follow these simple instructions.
1. Following the
①②③④⑤⑥⑦⑧⑨⑩
Picture A, dismantle the parts according
30
the order of