Publicité
Les langues disponibles
Les langues disponibles
receiver:
If the LED in the probe of the receiver is weak, please follow these steps:
•
Turn on the transmitter.
•
Set the function selector switch (6) to the right position (SCAN). The audio
status indicator lights up - the transmitter sends an audio signal to the
line.
•
Connect the RJ45 sockets of the transmitter and receiver to a network
cable.
•
Turn the volume control on the receiver to maximum.
•
If you do not receive an audio signal, replace the batteries.
•
Open the battery compartment.
•
Replace the battery. Mind the correct polarity.
•
Close the battery compartment.
•
Disposal of the flat battery should meet environmental standards.
Cleaning
If the instrument is dirty after daily usage, it is advised to clean it by using a
humid cloth and a mild household detergent. Prior to cleaning, ensure that
instrument is switched off and disconnected from external voltage supply and
any other instruments connected. Never use acid detergents or dissolvent for
cleaning.
EN 15
Publicité
