Publicité
Les langues disponibles
Les langues disponibles
G
CENTRAL POSITIONING AND ASSEMBLY OF BOSS FOR DOORS UP TO 9 m
B
LONG MOUNTING PLATE (FOR NON-AUTOMATED UP-AND-OVER DOORS)
Code ACG8188
Position the mounting plate with the upper section (slotted hole to feed electric cable) in top
position (Fig. 4).
Fix the mounting plate flush against the upper moving part of the up-and-over door in a central
position using 6.3 x 13 self-tapping screws (not included).
After the assembly's completion, either with the LONG
MOUNTING PLATE or with the SHORT MOUNTING PLATE, the
reducer's outlet-shaft must be placed in a distance of 80±10
mm from the pivot-axle of the up-and-over door's little arm.
LEVER APPLICATION
55 mm
35 mm
ASSEMBLY OF PAIR OF STRAIGHT TELESCOPIC LEVERS (code ACG8720) BETWEEN MOTOR AND
UPPER DOOR FRAME
N.B.: THE PAIR OF STRAIGHT TELESCOPIC LEVERS can be mounted when there is a 15 mm
minimum space guaranteed between the moving part of the door and the exterior door
frame containing the counterweight.
- Rivets or screws should be used to fix corner parts to the upper frame, in line with
measurements shown in Fig. 7: if at the measurement of 35 mm, one finds the reinforcing
plate of the door frame, it is possible to fix the brackets directly above this reinforcing
plate even if the measurement will not be maintained.
In the event that the up-and-over door is already pre-fitted for automated movement, use
the attachments provided. Do not use the angles provided.
- Insert the sliding arm sleeve into the angles and secure the pivots and split pins (Fig. 7).
- Make sure that the casing does not touch the up-and-over door movement levers when
mounted.
Note: The length of the sleeve and of the sliding arm must be modified in function of overhead door height. Trim the sleeve and the sliding arm so that the sleeve rests 40 mm from the center
of the drawbar pivot pin and the sliding arm avoids contact with the rotating dowels located on the angles (Fig. 8A)
4
ANGLE IRONS
40 mm
7
42
2
SHORT MOUNTING PLATE (FOR AUTOMATED UP-AND-OVER DOORS)
Code ACG8189
Calculate the length, L = C - 410 [mm], to which the mounting plate should be vertically fixed
(Fig. 5-6).
Position it on the appropriate vertical supports while keeping the upper part
(slotted hole to feed electric cable) in a vertical position facing upwards.
Fix the mounting plate in a central position using the four feedthrough holes, four 4 metric
screws (M6x 25) and self-locking nuts (not supplied).
L = C - 410 mm
LEVERS SLEEVE
8A
ASSEMBLY OF PAIR OF CURVED TELESCOPIC LEVERS (code ACG8722) BETWEEN MOTOR AND UPPER
DOOR FRAME
N.B.: The PAIR OF CURVED TELESCOPIC LEVERS should be mounted when there is less than
the 15 mm minimum space guaranteed between the moving part of the door and the
exterior door frame containing the counterweight.
- In the event that the up-and-over door is already pre-fitted for automated movement, use
the attachments provided. Do not use the angles provided.
- Insert the sliding arm sleeve into the angles and secure the pivots and split pins (Fig. 7).
- Make sure that the casing does not touch the up-and-over door movement levers when
mounted.
C
L
5
ANGLE IRONS
LEVERS SLEEVE
8B
L
6
Publicité
