Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
1. When the Blender is plugged in
and the main power On/Off toggle
switch is on, the Blender will go into
Standby mode (flashing white indicator
light). However, after 10 minutes of
no activity the Blender will go into
Sleep mode and the indicator light
will turn off.
• To wake up the Blender simply flip
the START/STOP toggle switch up
or down. This will put the Blender
back into Standby mode.
2. If the status indicator light flashes
an orange color, the Blender is in
error mode. This can be caused by:
using a spatula in the blender jar that
locks up the blade or having an ice
cube or hard food in a location that
locks up the blade.
• Correct the problem by turning off
the Blender using the dedicated off
switch in the back, or by unplugging
the Blender. Remove the blender jar
from the base, and clear the items.
Place the blender jar back on the
base, and then turn the Blender
back on to continue regular use.
All manuals and user guides at all-guides.com
3. If the Blender stops while blending:
4. If the ingredients of a recipe aren't
5. If you experience an overflow from
If the problem cannot be corrected:
See the "Warranty and service" section.
Do not return the Blender to the retailer;
retailers do not provide service.
• After 6 minutes of run time, the
Blender will automatically shut off
and go into Sleep mode, and the
LED light will turn off. You can wake
the Blender back up using the
toggle switches (Start/Stop or Pulse
High/Pulse Low). If the Blender stops
in less than 6 minutes, it is possible
there is an internal error with the
Blender. Contact an authorized
service center for assistance.
blending:
• There may be times when an air
pocket is created around the blade,
causing the ingredients to miss the
blending blade. Use your tamper to
assist during the blend by pushing
ingredients into the blade, or stir to
move ingredients around the blender
jar. If that does not work, stop the
Blender, remove the blender jar
from the base, and use a spatula to
rearrange ingredients in the blender
jar. For certain recipes, try adding
more liquid.
the blender jar:
• Unplug the Blender. Remove the
jar and jar pad. Clean the blender
housing, jar pad, and exterior
of the jar. Dry each part thoroughly,
and then re-install the jar pad.
• If the overflow is on or over the
control dial, it can be removed
by gently and firmly pulling it off.
After cleaning and drying, reinstall
the knob. To avoid damage to the
graphics, do not apply too much
force or use abrasive cleansers.
TROUBLESHOOTING | 11
Publicité
