Publicité
Les langues disponibles
Les langues disponibles
11. FITTING THE HANDLEBAR.-
Take the handlebar (4), remove screws
(11), position the ends of the handlebar
on the plate at the top of the main post
(83), Fig.13. Refit the screws (11)
removed previously.
12. FITTING MONITOR.-
Take hold of the cable (87), which is
sticking up out of the main post (83),
Fig.14, and plug it into the connector of
the electronic unit (1), as shown in
Fig.14
Take hold of the Hand-grip connectors
(2), sticking out of the main post (83),
and plug them into the connectors
located at the back of the monitor (1), as
shown in Fig.14.
Release screws (86), Fig.14, at the back
of the monitor.
Next, slide the front of the monitor onto
the plate on top of the main post (83) in
the direction of the arrow, Fig.14, push
the cables down into the main post
making sure not the pinch any of the
cables.
Replace
removed previously.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
the
screws
(86)
noises and possible damage.
LEVELLING.-
Once the unit has been placed into its fi
nal position, make sure that it sits fl at
on the fl oor and that it is level. This can
be achieved by screwing the adjustable
feet (47) up or down, as shown in
Fig.15.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (78) to
make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen position,
by lifting the rear of the unit up slightly
and pushing it, as shown in Fig.16.
Store your unit in a dry place, preferably
not subject to changes in temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have
any
customer services (see last page in
manual).
THE MANUFACTURER RESERVES
THE
RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE
17
queries
by
TO
MODIFY
OF
WITHOUT
phoning
THE
ITS
PRIOR
Publicité
