AEG KFA29SIO Notice D'utilisation page 76

76 www.aeg.com
Problem
You can hear a constant
beep noise.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
The heat setting changes
between two levels.
The control panel be‐
comes hot to the touch.
There is no sound when
you touch the panel sen‐
sor fields.
comes on.
comes on.
Possible cause
The fuse is blown.
You did not set the heat set‐
ting for 10 seconds.
You touched 2 or more sen‐
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
The electrical connection is
incorrect.
You put something on one or
more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
Power management oper‐
ates.
The cookware is too large or
you put it too close to the
control panel.
The sounds are deactivated.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
Remedy
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Activate the hob again and set
the heat setting in less than 10
seconds.
Touch only one sensor field.
Refer to "Pause".
Clean the control panel.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the in‐
stallation.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated sufficient‐
ly long to be hot, speak to an
Authorised Service Centre.
Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Put cookware on the zone.