Publicité
Les langues disponibles
Les langues disponibles
Temperature control knob
Vegetable container
Freezer Compartment
BEFORE INSTALLING THE APPLIANCE
Before connecting your fridge freezer to the power supply, check that the voltage stated on the rating label of your appliance corresponds to the voltage
in your home. A different voltage could damage the appliance.
The plug is the only way to unplug the appliance and should therefore be accessible at all times. To turn off main power to the appliance, turn it off and
then detach the plug from the outlet.
The appliance must be grounded. The manufacturer is not responsible for damages that may occur as a result of usage without grounding.
INSTALLATION
Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e.g. a
cooker, radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on each side of the cabinet.
For uneven surfaces, front feet can be aligned.
AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 16°C and 43°C. If these temperatures are exceeded, i.e. colder or warmer, the
appliance will not operate correctly. If the ambient temperatures are exceeded for long periods, the temperature in the freezer compartment will rise
above -18℃ and food spoilage may occur.
BEFORE PLACING FOOD IN THE APPLIANCE
Remove all packaging.
Allow the appliance to run empty for 2 – 3 hours so the compartments can cool to the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove manufacturing and transportation dust.
POWER FAILURE
If there is a power failure, do not open the door. Frozen food should not be affected if the power failure lasts for less than 18 hours.
Do not refreeze frozen foods that have thawed completely. The food may be dangerous to eat.
TEMPERATURE CONTROL
There is a temperature control knob located inside the fridge compartment. Adjust the control knob as desired to suit your individual preference.
0 is off setting – stop cooling
1 is cold setting
7 is coldest setting
The running time and temperature are affected by where the fridge freezer is located, how often the door is opened and the temperature of the room
the fridge freezer is located in.
When you use the appliance for the first time or after defrosting, adjust the control knob to the coldest setting for at least 2 hours before introducing
food to be stored, and then readjust to the middle setting.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow the refrigeration system pressures to equalise
before restarting.
Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile parts (shelves, accessories, etc.) or fix them into the
appliance to avoid any shock.
Relocate and install. If the appliance has been left on its side for any length of time, leave it standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly and natural gas, it is explosive. Therefore you
should be careful during shipment and installation to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by
damage to the cooler elements, move your appliance from open flame or heat sources and ventilate the room where the appliance is located for a few
minutes.
Shelves
Drawers
Adjustable foot
EN-4
Door shelves
Publicité
