Franke ADIGE Manuel D'utilisation page 8

1.SAFETY
EN
INFORMATION
For your safety and correct
operation of the appliance,
read this manual carefully be-
fore installation and use. Always
keep these instructions with the
appliance even if you move or
sell it. Users must fully know
the operation and safety fea-
tures of the appliance.
The wire connection has to
be done by specialized
technician.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or im-
proper installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
• If the instructions for installa-
tion for the gas hob specify a
greater distance, this must be
respected.
• Check that the mains voltage
corresponds to that indicated
inside of the hood.
• Means for disconnection must
wiring in accordance with the
wiring rules.
• For Class I appliances, check
that the domestic power supply
8
guarantees adequate earthing.
• Connect the extractor to the
minimum diameter 120 mm.
as short as possible.
• Regulations concerning the
discharge of air have to be
• Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
• If the extractor is used in con-
junction with non-electrical
appliances (e.g. gas burning
of aeration must be guaranteed
in the room in order to prevent
in conjunction with appliances
supplied with energy other than
electric, the negative pressure
in the room must not exceed
0,04 mbar to prevent fumes
being drawn back into the room
by the cooker hood.
• The air must not be discharged
hausting fumes from applianc-
es burning gas or other fuels.
• If the supply cord is damaged,
it must be replaced from the
manufacturer or its service
agent.
• Connect the plug to a socket
complying with current regula-
tions, located in an accessible
place.
-