How To Transport The Appliance; Preparation Of The Appliance - Fimap UP36 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

The procedure for the safe handling of the device is the following:
1. If the appliance is working, turn it off by positioning the main
switch (1) to "0" (Fig. 1).
2. Disconnect the plug of the power cable from the mains socket.
3. Position the control handle vertically, press the handle release
pedal (2) (Fig. 2) and move the handle away from you.
4. Wrap the power cable around the upper (3) (Fig.3) and lower (4)
cable holder (Fig.4).
OFF
1
1
Before beginning to work, it is necessary to:
1. Take the package to the dedicated maintenance area.
2. Remove the appliance and all the accessories from the box.
ATTENTION: Before performing the assembly of the
appliance, check that the power plug is disconnected from the
wall outlet, otherwise disconnect it.
1
1
5. Secure the body of the appliance to the brush head unit by means
of the knobs (6) (Fig.5).
ATTENTION: the two knobs (6) can be found inside the box.
6
5
9. Secure the handle to the body of the appliance using the supplied
screw. Insert the screw into the hole (11) at the front of the
appliance body (Fig.9).
ATTENTION: the tool to tighten the screw can be found inside
the box.

HOW TO TRANSPORT THE APPLIANCE

2
2

PREPARATION OF THE APPLIANCE

2
2
3
2
8
7
6
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
5. Tilt the appliance and carry it wherever you want.
3
3
3. Turn the vacuum hose nozzle (1) vertically. When in position,
secure it by shifting the release pedal (2) upwards (Fig.1).
4. Place the body of the appliance (2) over the brush head unit
(3) (Fig.2). Make sure to insert the latches (4) on the body of
the appliance (Fig. 3), into the slots (5) on the brush head unit
(Fig. 4).
4
3
6. Insert the brush head unit power plug (7) into the socket (8) on the
body of the appliance (Fig.6).
7. Insert the control handle (9) into the housing in the body of the
appliance (Fig.7).
8. Remove the front appliance body casing (10) (Fig.8).
9
7
10. Insert the nozzle with the handle (11) on the vacuum hose into the
widened hole of the vacuum pipe (12) (Fig.10).
11. Insert the nozzle (13) on the vacuum hose into the nozzle (14) on
the lower port of the appliance body (Fig.11).
12. Insert the nozzle (15) on the vacuum pipe into the nozzle (16) on
the brush unit (Fig.12).
26
5
4
5
4
10
8

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Up46

Table des Matières