Elektra Beckum BAS 315 Guide page 6

Installing the Precision Blade Guide
Loosen screw 127 and remove the Lower Blade Guide Ass`y. Install Precision Blade Guide with lower blade guide seat
with screw 127. Attach table to frame using the new holes.
Remove the standard 3-Roller Guide and install Precision Blade Guide with upper blade guide seat, using screws 122.
Setting
The two side bearings are adjusted by the knurled knobs as required and locked in position with the grub screws. The
rear thrust bearing can be set after loosening the wing bolt.
Wing screw Thrust bearing seat
Knurled setting screw
Body
Thrust bearing
Thrust bearing
Grub screw
(only on small model for BAS 315/350)
6