Marantz RC1400 Mode D'emploi page 22

All manuals and user guides at all-guides.com
If FULL is displayed no matter how many times
you try the learning operation, the remote
control cannot accept any more new codes until
some of the previously learned codes are deleted
from the memory. Delete some of the learned
buttons from the sources.
The M button r and > button y cannot be taught.
Only each one code can be learned for the LIGHT
buttons 1 and 2 !5 , regardless of the source.
Programming the Direct Buttons and
Rewriting Names
This example shows how to program codes
from other manufacturer products to the DVD
MENU button (D1) and change the display to
OSD.
6
LEARN
PAGE 1 2
1 Hold down the M button r for three
seconds or more.
The menu is displayed.
2 Press the D2 (LEARN) direct button t.
The LEARN setting (LEARN) indicator is displayed.
The
3 Press the DVD source button !4 .
The first page of the direct button screen is displayed.
There are four available pages. Pressing the > buttons
cycles through the pages in this order 1 → 2 → 3 → 4
→ 1.
4 Press the D1 (MENU) direct button t.
The
indicate that learning is ready.
5 Place the receiver sensor of the remote
control (top) so that it is facing the
transmitter of the DVD remote control
(top) at a distance of about 5 cm (2
inches).
6 Press and hold down the OSD button of the
transmitting DVD remote control, and
check that OK is displayed on the LCD.
The remote control has finished learning when OK is
displayed on the LCD.
RC1400N 01 ENG
7 8
LEARN LEARN
PAGE 1 2 PAGE 1 2
LEARN indicator then blinks.
LEARN indicator blinks, and then displays to
20
Page 20
Adobe PageMaker 6.5J/PPC
03.10.6, 4:17 PM