Marantz RC1400 Mode D'emploi page 21

All manuals and user guides at all-guides.com
1 Hold down the M button r for three
seconds or more.
The menu is displayed.
2 Press the D2 (LEARN) direct button t.
The LEARN setting (LEARN) is displayed. The
LEARN
3 Press the DVD source button !4 .
4 Press the
The
indicate that learning is ready.
5 Place the receiver sensor of the remote
control (top) so that it is facing the
transmitter of the DVD remote control
(top) at a distance of about 5 cm (2
inches).
6 Press and hold down the
of the transmitting DVD remote control, and
check that OK is displayed on the LCD.
The remote control has finished learning when OK is
displayed on the LCD.
If ERROR is displayed on the LCD, some error has
prevented the command from being learned. If this
happens, repeat the procedure for steps 4 and 5.
In some rare cases, ERROR may be displayed
repeatedly during the learning operation. In this case,
the transmitting remote control may have special
signal codes. These codes cannot be learned by this
remote control.
7 Follow the same procedure to make the
remote control learn the other buttons.
8 Repeat the procedure in steps 3 to 6 to
have the remote control learn the signal
codes from a TV, CD player, or other AV
equipment.
• When no buttons are pressed for approximately
one minute during the learning operation, the
remote control automatically returns to USE
mode.
• When programming the source buttons, switch
to the source in step 3, and then press the source
button again.
9 When you have finished programming the
codes for each button, press the M button
r.
The
newly stored codes can be used.
• If FULL is displayed on the LCD, the memory
cannot hold any more learned codes in LEARN
mode.
RC1400N 01 ENG
indicator then blinks.
(PLAY) !3 button.
LEARN indicator blinks, and then displays to
(PLAY) button
USE indicator is displayed on the LCD, and the
19
Page 19
Adobe PageMaker 6.5J/PPC
03.10.6, 4:17 PM