Marantz RC1400 Mode D'emploi page 19

All manuals and user guides at all-guides.com
8 To set the manufacturer number for
another source device, repeat the
procedure in steps 4 to 6.
9 After the settings are completed, press the
M button r.
10 Press the buttons on the remote control to
check that the DVD can be operated
correctly.
Setting Equipment Not Appearing in
Manufacturer Number List
Use the sequence function to set equipment
not appearing in the manufacturer number list.
You may still be unable to set some equipment
even when using the sequence function. In this
case, the remote control can be programmed
with codes individually.
In the sequence function, the power ON/OFF
codes are transmitted by pressing the remote
control buttons in order.
If the power for the equipment is left on, hold
down the button until the equipment is turned
off, and then release. This completes the
setting.
This example shows how to set a DVD player.
4
LEARN
1 2
1 Turn on the power of the DVD player.
2 Hold down the M button r for three
seconds or more.
The menu is displayed.
3 Press the D1 (PRESET) direct button t.
The Preset setting (P-SET) is displayed.
4 Press the DVD source button !4 .
5 Hold down the CH+ or CH– button !9 for
one second or more.
6 Press the CH+ button !9 repeatedly in the
interval for one second.
The signal is transmitted, and the display cycles
through the code number.
Press the CH– button to go back to a number screen.
7 Release the button once the DVD player
turns off.
8 Press the OK cursor button @0 .
RC1400N 01 ENG
5 7
LEARN LEARN
1 2 1 2
17
Page 17 03.10.6, 4:17 PM
Adobe PageMaker 6.5J/PPC