Publicité
Les langues disponibles
Les langues disponibles
Operation
Hanging the grass bag H
Only when the motor is not running and the
cutting blade is not moving.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective flap.
djustment of cutting height J
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Press button (1).
2. push chassis downwards or pull upwards, as required.
3. Release button at required cutting height (2).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do not
se cutting position too low when mowing very hight or wet grass.
We recommend an average cutting height of 4,0 - 5,0 cm.
This lawnmower is equipped with a soft starter
for the motor. Once the handle switch
has been actuated, the operating speed of the
motor is reached after approx. 2 seconds.
fter the mower has been switched off via the
handle switch, it can only be switched on again
after a period of
approx. 5 seconds. during this period, the
braking energy released from the motor is fed
back into the battery.
It is also possible to switch on the lawnmower
when the battery electronics are not switched on.
•
lways remove the switch key if you mowe
away from the lawnmower or when carrying out
maintenance work.
Checking the charge K
To check the charge of the battery, set switch (1) briefly on
and off. Do not leave switch (1) on.
Maintenance
Cleaning
Note: Remove switch key before cleaning or per-
forming maintenance work. ttention: Keep hands
clear of moving blade.
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water. Keep mower in a dry room.
Winter Storage
• Clean mower thoroughly before storing away.
• Have your mower thoroughly checked once a year by an
approved Service Centre.
• Do not store it in a wet or humid place.
All manuals and user guides at all-guides.com
Starting and Stoping K L M
Emptying of Grassbox N
Tips for mowing O
Safety switch
Change of cutter blade P
• Switch on motor with mowerplaced on level and firm ground
• not in high grass - alternatively tilt slightly
K M
Switch-on motor
1. Insert the key (K, 2)
2. Depress button and hold (M, 1).
3. Lift up bar (M, 2).
4. release button (M, 1).
M
Switch-off motor
Release bar (2).
• the flap drops down when grassbox is full
• To ensure properfunctioning of the indicator it is important
that the grilles beloware kept clean using a hand brush.
Only when mower is stationary and rotating blade
has come to complete standstill.
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
•
lways turn the mower on a surface that has already been
mowed.
In case of overload or blocking, the motor shuts down
automatically!
Remove switch key and eliminate problem.
Overload:
Cutting height is too low, or forward speed is too fast
Blocking:
Foreign object in cutting area (e.g. branches)
The machine can be switched on again after about 5 min.
TTENTION! Change of blades or re-sharpening
should only be carried out by an approved service
station as the work should include the proper che-
cking of the blade balance in accordance with safety regu-
lations.
For changing the cutter bar please follow illustration. Torque
wrench setting for screw 18–22 Nm.
Use original spare parts only.
L
15
Publicité
