Publicité
EN
A - Cover (fabric)
B - Baby-hugg inlay
C - Push button for releasing Pebble Plus
from pushchair
D - Ergonomic handle
E - Belt hook for shoulder part of belt
F - Height adjustment shoulder belts
G - Instruction manual
H - Storage compartment
I - Small hook for clamping sun canopy
J - Sun canopy (built-in)
K - Carrying handle
L - Storage flap sun canopy
M - Push button for adjusting carrying
handle
N - Shoulder belts with removable belt pads
O - Belt hook for lap part of belt
P - Belt buckle
Q - Crotch strap with belt pad
R - Mounting bars for base
S - Belt tensioner strap
SAFETY
General instructions
• Do not use the Pebble Plus for more than 10 years.
Pebble Plus and your baby
1. Make sure you can fit no more than one finger
between the harness and your baby (1cm).
If there is more space than 1 cm, tighten the
harness belt further.
2. Only use the seat reducer of the car seat
when the shoulder belts are in the lowest
position.
WARNING:
• Never place the car seat on an
elevated surface (such as a table or chair).
• Install the car seat only rearward-facing in the car.
Pebble Plus car use
1. Only use a forward-facing seat that is fitted
with a 3-point safety belt that complies with the
ECE R16 standard.
2. Make sure the car safety belt buckle runs in
I
I
38
Pebble Plus
Maxi-Cosi
a straight line and stays below the belt hook of
the car seat.
3. The car safety belt must be threaded tight
along all blue markings. For a proper installation,
check the instruction in this manual and the
sticker on the side of the car seat.
Use in airplanes
• Installation of the Pebble Plus on an aircraft seat
di ers from the installation on a car seat.
• Installing the Pebble Plus with a 2-point safety belt is
only allowed when used in an aircraft.
• In an aircraft, the Pebble Plus may only be used on
forward-facing passenger seats.
• To install Pebble Plus, place the infant carrier rearward
facing on the passenger seat.
Route the webbing of the-2point safety belt through
the belt guides. (1,2)
Lock the buckle of the 2-point safety belt. (3)
And tighten the 2-point safety belt by pulling on the
tightening strap. (4)
• The handle of the Pebble Plus must be in upright
position.
• The belt buckle must not be positioned between the
belt hooks of this car seat. Otherwise a safe attachment
does not exist.
• To uninstall Pebble Plus, open the buckle of the 2-point
safety belt by lifting the lever of the buckle. (5)
And remove the webbing of the 2-point safety belt from
the guides. Make sure the Pebble Plus does not fall from
passenger seat when opening the buckle.
• The Pebble Plus must remain belted on the aircraft
seat, even when unoccupied.
• The Pebble Plus is only for use on an aircraft seat
authorized by the airline.
• Do not install the Pebble Plus in the area of airbag
deployment.
• Instructions of the cabin crew must be followed.
• The safety of your child for not complying with the
installation and instruction manual is not guaranteed.
Care
The cover, cushions and belt pads of the car seat can be
removed in order for these to be cleaned. They can be
machine-washed.
Publicité
