Garland GRASS 765 SB Manuel D'instructions page 40

English
Place yourself behind the mower
as shown in the figure and pull
the Starter rope until the engine
starts.
Adjust the appropriate number
of revolutions with the throttle lever (between
).
Allow the engine to warm up for a few minutes before
starting to use the machine.
6.3.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat and stable surface in
order to start it.
Place the accelerator lever in the position
Push the safety switch bar until it touches the upper
handle.
Place yourself behind the mower and pull the Starter
rope until the engine starts.
Adjust the appropriate number of revolutions with the
throttle lever. If after a few tries the engine does not
start, follow the instructions for starting cold-starting
the engine.
6.4. STOPPING THE ENGINE
Place the throttle lever in the minimum speed position
and allow the engine to remain idle
seconds.
y
.
Turn of the engine by
releasing the safety switch.
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
6.6. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Do not start the machine in a room or enclosure.
The exhaust gases and fuel and oil vapors
contain carbon monoxide and harmful
40/160