Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Grease filters
Carbon filter
Removing the door
Light bulbs
Removing the grease filters
Open the lock on the filters and remove the filters.
• Attention! Clean the grease filters each month with soapy water.
When washed in a dishwasher, the grease filter may be discoloured
slightly. This is normal and does not affect its filtering capacity.
Replacing the carbon filter
The saturation of the filter depends on the intensity of use. However,
the carbon filter needs to be replaced at least every four months.
• Attention! The carbon filter cannot be washed for reuse. Saturated
carbon is not environmentally friendly. Change the filter regularly.
• Open the door and push the brackets on the side of the door
inwards. Pull the door out of the guide.
• Place the panel door on the cooker hood again, first at the top and
then at the bottom.
Changing the light bulbs
Disconnect the hood from the electricity. Attention! Prior to touching
the light bulbs, ensure that they have cooled down.
1. Using a small screwdriver or equivalent tool, carefully pry loose the
light cover.
2. Remove the damaged light bulb
3. and replace with a 12V 20W (max) G4 halogen lamp. Ensure that
you do not touch the light bulbs with bare hands.
4. Close the light cover (it will snap shut).
If the lights do not work, make sure that the lamps are fitted properly
into their housings before you call for technical assistance.
GB 9
Publicité
