Publicité
Les langues disponibles
Les langues disponibles
986W/986KFRS Chelsea Pub Stool Addendum
Before beginning assembly, check that the quantities of the parts received match
A - Wood Jig - Qty. 1
B - Drill Bit - Qty. 1
The following steps are required to reinforce the structure of the stool. Follow each step carefully.
IMPORTANT: The enclosed Wood Jig (A) is a single application item. If you are reinforcing
more than one pub stool, use the individual Wood Jig (A) in each kit for each pub stool. Do
not reuse the Wood Jig (A). Instead, throw it away after completing the following steps.
1. If your stool has been fully assembled, remove the seat. There are four Phillips Head Screws
that hold the seat to the stool frame. Proceed with the following steps.
If you stool has not been assembled, complete the following steps to reinforce the pre-
assembled side assemblies before putting the seat onto the frame.
© 2005 Whittier Wood Products – P.O. Box 2827, Eugene, Oregon 97402
Toll Free: 800-653-3336 – Phone: 541-687-0213 – Fax: 541-687-2060
Corner Reinforcement Kit
those on the parts list.
Presented by Whittier Wood Products
Email: info@whittierwood.com
C - #8 x 1 1/4" Flat
Head Screw - Qty. 8
D - #8 x 2" Flat Head
Screw - Qty. 4
F U R N I T U R E
Publicité
