Publicité
Les langues disponibles
Les langues disponibles
Wood Jig (A)
FIG 4A
4. Align the Wood Jig (A) in the back right corner of the aprons as shown in FIGURE 4A and 4B.
Make sure the holes in the Wood Jig (A) are towards the Back Apron and the angled surface of
the jig (that has a black line) is facing and against the inside surface of the Right Apron.
IMPORTANT: The inside bottom corner of the Wood Jig (A) needs to be flush to the bottom
edge of the Right Apron. See FIGURE 4B for precise location.
Hold the Wood Jig (A) tightly in the corner and insert the Drill Bit (B) into each hole and drill each
pilot hole into the stool frame. Drill the same 2" depth as done in Step 3.
5. Remove the Wood Jig (A) and
drive a #8 x 1 1/4" Flat Head
Screw (C) into each of the pilot
holes. See FIGURE 5.
6. Repeat Steps 2 – 5 for the front
and back left apron corners. Make
sure the angled edge of the Wood
Jig (A), with the black stripe, is
always facing and against the Left
Apron.
Right Apron
Back Apron
FIG 4B
986W/986KFRS Chelsea Pub Stool Addendum - Page 3
Back Apron
A
Flush at
Right Apron
this point
C C
FIG 5
Black line
facing Right
Apron
Publicité
