Subaru H001SFL401 Instructions D'installation page 9

6
REMOTE ENGINE START WIRE HARNESS CONNECTIONS, continued
REMOTE ENGINE START WIRE HARNESS ROUTING
12. Route the remote engine start wire harness, with 12-pin
and 8-pin ECU connectors, to the center console and
secure with two (2) of the supplied 20cm tie wraps at
the white tape rings. Trim off the excess tie wraps.
(FIGURE Z)
NOTE: The lower tie wrap is routed through a slot
in the vehicle's HVAC assembly.
13. Continue to route the remote engine start wire harness
behind the center console and secure with one (1) of
the supplied 20cm tie wraps at the white tape ring. Trim
off the excess tie wrap. (FIGURE AA)
NOTE: The tie wrap is routed through a slot in the
vehicle's HVAC assembly.
PART NUMBER ISSUE
H001SFL401
DATE
02 18 Sep 2018
FIGURE Z
FIGURE AA
SUBARU OF AMERICA
9 OF 13