Subaru H001SFL401 Instructions D'installation page 5

5
REMOTE ENGINE START ECU MOUNTING
1. Locate the glove box inner cover and remote engine
start ECU. Using alcohol, clean the back side of the
glove box inner cover and ECU, as shown. (FIGURE
M) Using the supplied double sided tape, remove the
three (3) small release liners and attach the tape to the
glove box inner cover. Ensure the tape is positioned
against the vertical character line and fl at against the
multi-level inner cover. Press fi rmly in place for at least
30 seconds. (FIGURE N)
NOTE: Ensure the double sided tape is positioned
away from any obstructions on the glove box inner
cover.
2. Remove the one (1) large release liner from the double
sided tape and attach the remote engine start ECU.
Ensure the corner of the ECU, closest to the white 8-pin
connector, is fl ush with the upper left corner of the tape,
as shown. Press fi rmly in place for at least thirty (30)
seconds. (FIGURE O)
3. Using alcohol, clean the lower, front side of the ECU,
as shown. (FIGURE O)
4. Remove the release liner from the one (1) supplied wire
harness clip and attach it to the lower, front side of the
ECU, as shown. Press fi rmly in place for at least ten
(10) seconds. (FIGURE P)
5. Using one (1) of the supplied 39cm tie wraps, secure
the remote engine start ECU to the glove box inner
cover. Trim off the excess tie wrap. (FIGURE P)
Mount Corner
of ECU Flush
with Corner of
Foam Tape
Clean with
Alcohol
FIGURE O
PART NUMBER ISSUE
H001SFL401
DATE
02 18 Sep 2018
Clean with
Alcohol
FIGURE M
Vertical
Character
Line
FIGURE N
FIGURE P
SUBARU OF AMERICA
Obstruction
5 OF 13