Subaru H001SFL401 Instructions D'installation page 10

6
REMOTE ENGINE START WIRE HARNESS CONNECTIONS, continued
REMOTE ENGINE START ECU CONNECTIONS
14. Route the remote engine start wire harness, with 12-
pin and 8-pin ECU connectors, through the cabin fi lter
access opening of the glove box inner cover, as shown.
Re-connect the glove box lamp connector to the lamp
on the glove box inner cover. Re-install the glove box
inner cover by engaging the six (6) pressure clips and
secure with seven (7) Phillips screws. (FIGURE BB)
NOTE: Ensure the upper 8-pin header of the remote
engine start ECU is clear of the metal dashboard
bracket. (FIGURE BB)
15. Route the remote engine start wire harness to the
remote engine start ECU. Plug the remote engine start
wire harness 12-pin and 8-pin connectors into the ECU.
(FIGURE CC)
16. Reach behind the glove box inner cover and route
the remote engine start wire harness through the wire
harness clip. (FIGURE DD)
NOTE: Ensure the remote engine start wire
harness is NOT too tight to avoid stress on the ECU
connectors.
PART NUMBER ISSUE
H001SFL401
DATE
02
18 Sep 2018
Ensure
Clearance
from the
Bracket
FIGURE BB
FIGURE CC
View From
Behind the
Glove Box
Inner Cover
FIGURE DD
SUBARU OF AMERICA
Dashboard Bracket
ECU
10 OF 13