Subaru H001SFL401 Instructions D'installation page 12

9
SYSTEM POWER-UP
1. After all the connections are complete, re-connect the vehicle's negative battery terminal. Using a 10mm socket/
torque wrench, tighten the 10mm nut to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
2. Start the vehicle at least one (1) time using the ignition key prior to activating the remote engine start system. This
is required to allow the vehicle's electronic systems to re-synchronize.
3. With the vehicle running via the ignition key, verify that the instrument cluster airbag light turns off. If the airbag light
remains on, refer to the vehicle service information for troubleshooting.
4. With the vehicle running via the ignition key, apply the brake pedal and shift the transmission out of park. Turn off
the engine and confi rm the ignition key cannot be removed from the ignition switch. If it can, confi rm the key lock
solenoid connector is connected and the delivery (test) mode fuse is removed, then re-check.
5. Refer to the vehicle Owner's manual for the Power Window Reset Procedure to restore the power window functions.
10
SYSTEM REGISTRATION
NOTE: Once the Ignition is turned ON, the system will exit System Registration after 2 minutes.
DST-i SETUP
Plug the DST-i
diagnostic plug
into the vehicle's
diagnostic connector
REGISTRATION
on the DST-i, select
on the DST-i, select
on the DST-i, select
display "Successful
[Remote Engine Start
PART NUMBER ISSUE
H001SFL401
Insert an ignition key
into the ignition
cylinder and turn to
the ON position
Using the arrows Using the arrows
on the DST-i, select
PRESS
"Name" A "Impreza"
DST-i screen will
Using the arrows
display "Press YES if
PRESS
A
it is a smart system,
"Immobilizer"
otherwise press NO.
Using the arrows
Using the arrows
on the DST-i, select
PRESS
"Remote Engine Start
A
"YES"
CM Registration"
DST-i screen will
Using the arrows
on the DST-i, select
CM Registration]
Press OK"
DATE
02
18 Sep 2018
Press and hold the DST-i
"B" and "A" buttons
simultaneously for
approximately 5 seconds
to enter stand alone mode
Using the arrows
PRESS on the DST-i, select
A
"Model year"
Using the arrows
on the DST-i, select
"NO"
DST-i screen will
display "Execute
PRESS
Remote Engine Start
A
CM Registration?
Press YES or NO
Registration
PRESS
A Complete
"OK"
SUBARU OF AMERICA
Using the arrows on the
DST-i, select Diagnostic
and Press "A" to proceed
to Registration
Using the arrows on
PRESS the DST-i, select the
A
vehicle model year
"XXMY"
PRESS
A
DST-i screen will
display "Check if
PRESS
A
Ignition SW is
turned ON."
Using the arrows
on the DST-i, select
"YES"
PRESS
A
12 OF 13