Subaru H001SFL401 Instructions D'installation page 7

6
REMOTE ENGINE START WIRE HARNESS CONNECTIONS, continued
8-PIN IGNITION SWITCH CONNECTIONS, continued
5. Carefully fold back the remote engine start harness 8-pin
foam wrapped male connector. Plug the factory 8-pin
female ignition switch connector into the remote engine
start wire harness 8-pin male connector. (FIGURE T)
6. Route the remote engine start wire harness inside the
plastic channel on the left side of the factory ignition wire
harness. Engage the three (3) plastic tabs to close the
plastic channel. (FIGURE U)
7. Secure the remote engine start wire harness 8-pin foam
wrapped male connector to the vehicle's wire harness
using one (1) of the supplied 39cm tie wraps. Secure
the remote engine start wire harness above the plastic
channel using one (1) of the supplied 39cm tie wraps
at the white tape ring. Trim off the excess tie wraps.
(FIGURE V)
NOTE: Ensure the tie wrap clasps are rotated
upward to avoid contact with the steering column
shroud after re-assembly.
8. Continue to route the remote engine start wire
harness, with 4-pin and 2-pin pre-fi t connectors, along
the vehicle's wire harness toward the left side of the
dashboard and secure with three (3) of the supplied
39cm tie wraps at the white tape rings. Trim off the
excess tie wraps. (FIGURE W)
FIGURE V
PART NUMBER ISSUE
H001SFL401
DATE
02 18 Sep 2018
FIGURE T
Plastic Tabs
FIGURE U
FIGURE W
SUBARU OF AMERICA
7 OF 13