Subaru H001SFL401 Instructions D'installation page 4

4
VEHICLE PREPARATION, continued
7. Open the glove box and press inward on the sides of the
glove box to disengage the retaining tabs from the glove box
inner cover. Disconnect the strut from the glove box.
(FIGURE I)
8. Using a panel removal tool, carefully remove the right side
dashboard panel by starting at the bottom access notch
and working upward to disengage four (4) pressure clips.
(FIGURE J)
9. Using a panel removal tool, carefully lift upward to disengage
four (4) pressure clips and one (1) fi nger clip and then pull
rearward to remove the passenger's side ornament panel.
(FIGURE K)
10. Using a Phillips screwdriver, remove seven (7) Phillips screws
securing the glove box inner cover. Disengage the six (6)
pressure clips and disconnect the glove box lamp connector
to remove the glove box inner cover. (FIGURE L)
PART NUMBER ISSUE
H001SFL401
DATE
02
18 Sep 2018
FIGURE I
FIGURE J
FIGURE K
FIGURE L
SUBARU OF AMERICA
4 OF 13