Subaru H001SFL401 Instructions D'installation page 8

6
REMOTE ENGINE START WIRE HARNESS CONNECTIONS, continued
4-PIN & 2-PIN PRE-FIT CONNECTIONS
9. Locate and release the vehicle's 4-pin and 2-pin
pre-fi t connectors secured to the vehicle's wire
harness with breakaway tape near the dash wall
and to the left of the brake pedal assembly.
(FIGURE X)
10. When the vehicle's 4-pin and 2-pin pre-fit
connectors are free from the breakaway tape,
unplug and discard the 2-pin mating connector/
wire jumper. (This is used for the power window
interrupt circuit).
11. Plug the remote engine start wire harness 4-pin
and 2-pin connectors into the corresponding pre-fi t
connectors and secure to the vehicle's wire harness
with one (1) of the supplied 39cm tie wraps.
Trim off the excess tie wrap. (FIGURE Y)
FIGURE Y
PART NUMBER ISSUE
H001SFL401
DATE
02
18 Sep 2018
FIGURE X
SUBARU OF AMERICA
Brake Pedal
Assembly
8 OF 13