Samaref 600 Serie Manuel D'utilisation Et D'entretien page 32

UK
FIG. 7
Once the REFRIGERATOR CABINET is positioned in the intended area,
make sure it is level using the adjustable feet (FIG. 7).
Do not located the REFRIGERATOR CABINET near
heat sources or in areas with elevated temperatures
since this could lower performance and increase
equipment wear. Leave at least 50cm between the
equipment and any upper surface (FIG. 8).
Make sure the power cable is not under the
equipment.
3.6 SPACE NEEDED FOR MAINTENANCE
When installing the REFRIGERATOR CABINET, enough space must
be left around it for maintenance operations (FIG: 9).
3.7 ELECTRICAL CONNECTION
The electrical connection must be done by a qua-
lified technician according to the manufacturer's
instructions and in compliance with current safety
standards.
Disconnection from electrical power must be possi-
ble by pulling the plug or by a bipolar mains switch
located upstream from the outlet.
The power cable must only be replaced by authorized
personnel.
Do not use extension cords or multiple adapters.
Make sure the voltage on the serial number label
(FIG: 10) corresponds with the one at the installation
location.
Connections must be in compliance with current standards.
Earthing of the equipment is required by law.
Connect the power cable to the electrical outlet.
3.8 DOOR MOUNTING
REFRIGERATOR CABINETS with one door are supplied with right-
hand opening.
Assembly and dis-assembly of the door must be
performed by qualified and authorized technicians.
32
REFRIGERATOR CABINETS
FIG. 8
FIG. 9
FIG. 10
MIN
50 cm