Télécharger Imprimer la page

Samaref 600 Serie Manuel D'utilisation Et D'entretien page 31

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 54
REFRIGERATOR CABINETS
3 INSTALLATION
Personal safety devices must be used during this
operation.
3.1 TRANSPORT
The REFRIGERATOR CABINET is shipped on a pallet and protected
by its packaging.
The REFRIGERATOR CABINET should always and only be transported
in a vertical position (indicated Up-Down on the packaging) (FIG: 5).
Installation and start-up must be performed by
qualified and authorized personnel.
3.2 UNPACKING
Cut the sealing tape.
Slide the cardboard packaging up and remove any protective films
from the product (internal and external).
After unpacking the REFRIGERATOR CABINET, inspect
for any damages. Immediately inform the courier and
Dealer in the event of obvious damage.
The REFRIGERATOR CABINET should always be
transported vertically, resting on the pallet supplied
with it (FIG. 6).
3.3 PACKING LIST
Check the condition and quality of the REFRIGERATOR CABINET and
materials, comparing them with the Packing List.
The items supplied include:
- Use and maintenance instruction manual.
3.4 ENVIRONMENTAL SPECIFICATIONS
When positioning the equipment, keep in mind that its operation is guaranteed only in environmental conditions with a temperature of
+18°C ÷ +43°C.
3.5 POSITIONING
Check the suitability of the electrical plug installed (SHUKO) according to current national laws. Replace the plug if not
in compliance; the replacement must be done by qualified personnel.
Check that the mains voltage corresponds with that of the REFRIGERATOR CABINET as reported on the label.
Before positioning the equipment, put on safety clothing and gloves for moving it since the metal parts could be sharp.
Position the product in a clean, dry and well-ventilated area. The refrigerator is set for operation in environments where
the temperature is between +18°C and +43°C (Tropicalized Compressor) - Climate Class T -.
The equipment should be located far from heat sources and in places with sufficient ventilation.
Do not install the equipment in places where there are explosive and/or corrosive gases/powders.
Make sure the equipment is level and on flooring that is capable of supporting its weight and in a suitable area based
on its dimensions and use.
Make sure the product is not near any heat sources.
FIG. 5
FIG. 6
UK
31

Publicité

loading

Ce manuel est également adapté pour:

700 serie1200 serie1400 serie