Jacuzzi Sasha Mi Fiche Technique De Pre-Installation page 8

Hydraulic connections
For connection to the water supply (position 5) we advise us-
ing pipes with min Ø 14 mm; these pipes must have a 1/2" M
pipe joint.
A tank (optional) may be installed for automatic filling of the
bio sauna/ Roman sauna container; this tank must be connected
to the water supply (cold water) with an 1/2" M fitting (pos. 5S).
In order to ensure correct operation, the pressure and flow
rate values must also comply with the values specified in the rel-
evant "Hydraulic specifications".
Where "hard" water is present, it is advisable to install
a decalcifier in the water system supplying water to the
appliance, in order to reduce and/or avoid calcareous
deposits.
ATTENTION: (IEC 60335-1/A2) The pressure of the wa-
ter system supplying water to the appliance must not
exceed 600 k Pa (6 bar).
INSTALLING THE BACKFLOW PROTECTION DEVICE (DIS-
CONNECTOR) – OPTIONAL
Changes in pressure may occur in the plumbing. This may cause
backflow in the water pipes. If this happens, the polluted water
coming from the shower cubicle may be drawn into the public wa-
ter mains.
Should this problem arise, or where required by local law, Jacuzzi
recommends installing a specific kit which includes a protective de-
vice (disconnector) and related accessories. Please see the informa-
tion supplied in the manual in the kit as regards the space require-
ments and the disconnector installation zone.
Electrical connections
Sasha Mi comes with a multi-pole switch, supplied with a 500 cm.
cable connected to the equipment electrical box, as indicated in pos.
2S, to which the power main is connected.
This switch must be connected to an area that complies with the
safety regulations as specified by current legislation in force.
The electrical connection can be made as follows:
- single-phase line (220-240V 1~)
- three-phase line consisting of three phase conductors +
neutral conductor (380-415V 3N~)
The rated power supply voltage of the equipment is al-
ways 220-240V.
The equipment can also be installed in Countries where
the 220-240V voltage is supplied by a two-phase system. For
the connection please refer to the instruction manual.
Some models allow you to connect the appliance to an alarm
circuit (provided, in the area marked with the bell symbol), a
bipolar cable with characteristics not inferior to type H 05 VV-F
2x2.5 mm 2 (220-240V - 2A max.); this cable must be used in order
to ensure that the cable clamp attached to the box offers ad-
equate protection (water tight) as detailed by legislation.
Audio system
The Sasha Mi audio speakers can be connected to a cable audio
system: this must be done by laying out a cable as indicated n
pos. 3.
Upon request, an audio kit is available, which can be installed in
the appliance's appropriate equipment zone, to which the speak-
ers will also be connected.
sauna
10W-8Ω 10W-8Ω
Remote control system arrange-
ment (where present)
The "sauna" and "hammam" functions can be controlled
through a computer which interfaces with a remote system (sc)
via an Ethernet (LAN) network:
sc
it is also possible yo use a smartphone or tablet computer,
which interfaces via a wireless network (WLAN/Wi-Fi):
8
hammam/shower
10W-8Ω 10W-8Ω
LAN