Publicité
Les langues disponibles
Les langues disponibles
!
WARNING
Scalding Hazard!
Do not perform any work on a pressured hot water line.
Serious injury could result. Only qualified plumbers should
perform plumbing work. Do not attempt any work on the dish-
washer hot water supply plumbing until you are certain the hot
water supply is shut off.
NOTICE
Temperatures required for soldering and sweating will damage the
dishwasher. If plumbing lines are to be soldered or sweated, keep the
heat source at least 6 inches (152.4 mm) away from the dishwasher.
Hot Water Supply
The hot water heater should be set to deliver approximately 120° F (49° C)
water to the dishwasher. Water that is too hot can cause some detergents
to lose effectiveness. Lower water temperatures will increase run times. The
hot water supply pressure must be between 15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
•
If using a solder joint instead of a compression fitting, be sure to complete
all solder connections before connecting the water supply line to the
dishwasher.
•
Make sure there are no sharp bends or kinks in the water line that might
restrict water flow.
•
Always use appropriate seals when making plumbing connections.
•
Before connecting the water supply line to the dishwasher, flush the
incoming water line for approximately 5 minutes to clear any foreign
material.
•
Properly tighten all water connections. Not doing so could result in a leak.
•
Check local plumbing codes for approved plumbing procedures and
accessories. All plumbing should be done in accordance with national
and local codes.
•
If using copper tubing or other material not depicted in this manual for
water supply, defer to a licensed plumber for proper installation.
22
Water Inlet Connection
Publicité
