GYS MULTIWELD 200M-C Mode D'emploi page 15

INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorized by the manufacturer should perform the installation of the cutting equipment. During set up, the
operator must ensure that the machine is unplugged. Connecting generators in a series or a parallel circuit is forbidden.
It is recommended to use the welding cables supplied with the unit in order to obtain the optimum product settings.
DESCRIPTION
Thank you for chosing this machine. To get the best use from your machine, please read the following carefully :
The MULTIWELD range are semi-automatic MIG/MAG, MMA and flux cored wire welding stations. They are manual settings ma-
chine, with the help of the table printed on the product. They are recommended for welding steel, stainless steel and aluminium.
MACHINE SUPPLIED WITH
MULTIWELD 200M-C
3 m
2 m - 16 mm²
2 m - 16 mm²
POWER SUPPLY
The MULTIWELD 200M-C is supplied with a 16 A CEE7/7 plug and may only be used in a single-phase 230 V (50 - 60 Hz) three-
wire electrical installation with a grounded neutral conductor.
The absorbed effective current (I1eff) is displayed on the machine, for optimal use. Check that the power supply and its protection
(fuse and/or circuit breaker) are compatible with the current needed by the machine. In some countries, it may be necessary to
change the plug to allow the use at maximum settings.
USE WITH EXTENSION CABLES
All extension cables must have an adequate size and section, relative to the machine's voltage.
Use an extension that complies with national safety regulations.
MULTIWELD 200M-C
DEVICE PRESENTATION (FIG. I)
1- Reel support
2- Handles
3- Digital displays
4- Adjustement of welding settings
5- European standard torch connection
6- Polarity reversal cable
7- Earth clamp connector
CONTROL BOARD MMI (FIG. V)
1- Overheat/Overcurrent indicator
2- Voltage display
3- Current display
4- Green light «ON»
SWITCHING ON
The ON/OFF switch is located at the back of the machine. Turn the switch on the «I» position to start the generator. This switch
must not be turned off (to «O») while welding.
MULTIWELD 200M-C
066588
The accessories supplied with the MULTIWELD
generator may only be used with this product.
Input voltage
230 V - 1~
Wire section of extension cord (<45m)
8- Lifting eyes
9- Gas connector
10- On/off switch
11- Power supply cable
12- External grill
13- Plug 36V AC for gas preheater
14- Switch MIG/ MMA
5- Welding arc dynamic adjustment
6- Wire speed adjustment (MIG) / Current setting adjustment (MMA)
7- Voltage setting adjustment
2.5 mm²
EN
15