Publicité
Les langues disponibles
Les langues disponibles
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the top right green light will illuminate
and stay green (Fig. 2).
Fig. 2
Power on
green
3. Place the battery pack into the charger by sliding the
pack to lock it into position. When you insert the battery
into the charger, the top right green light will go off,
and the top left red light will illuminate to indicate that the
battery is charging (Fig. 3).
Fig. 3
Battery pack
Charging
red
Charger
Fully
Charged
green
4. When the charger light turns green, the battery is fully
charged (Fig. 3).
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in
1 hr 50 min (between 32ºF/0ºC and 113ºF/45ºC).
5. If the light indicators do not come on at all, check that
the battery pack is fully seated into the bay. Remove
the battery pack and reinsert. If the problem persists,
contact an authorized Snow Joe
call the Snow Joe
+ Sun Joe
®
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the battery from the
charger by pressing the push lock button and sliding the
battery backward to unlock it from the charger (Fig. 4).
Charger
+ Sun Joe
dealer or
®
®
customer service center at
®
Fig. 4
Battery pack
7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Charging a Hot or Cold Battery Pack
A red and green flashing indicator light on the charger base
indicates that the battery pack temperature is outside the
charging range. Once the pack is within the acceptable
range, normal charging will take place and the red light will
be continuous. Hot or cold battery packs may take longer to
charge.
Lithium-Ion Charging Status
Battery Pack
Charger Base
Temperature
Indicator Light
Too hot
Flashing
Normal range
Red
Too cold
Flashing
Assembly
m
WARNING!
The hedge trimmer must be fully assembled
before operation! Do not use a hedge trimmer that is only
partly assembled or assembled with damaged parts!
Follow the assembly instructions step-by-step and use the
figures provided as a visual guide to easily assemble the hedge
trimmer.
Do not insert the battery before it is completely assembled.
NOTE: Take care of small parts that are removed during
assembly or when making adjustments. Keep them secure to
avoid loss.
1. Snap the front handle into place on the unit. (Fig. 5).
10
Push lock
button
Charger
Charging
Status
Not charging
Normal charging
Not charging
Publicité
