Publicité
Les langues disponibles
Les langues disponibles
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliance
with a brush. This operation will improve
the performance of the appliance and
save electricity consumption.
Take care of not to damage the
cooling system.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason it is recommended
that the outer casing of this appliance is
only cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment
to the mains supply.
6.2 Defrosting the freezer
A certain amount of frost will always form
on the freezer shelves and around the
top compartment.
Defrost the freezer when the frost layer
reaches a thickness of about 3-5 mm.
About 12 hours prior to defrost-
ing, set the Temperature Regula-
tor toward higher settings , in or-
der to build up sufficient chill re-
serve for the interruption in oper-
ation.
To remove the frost, follow the instruc-
tions below:
1.
Switch off the appliance and discon-
nect the mains plug from the mains
socket.
2.
Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
CAUTION!
Do not touch frozen goods with
wet hands. Hands can freeze to
the goods.
3.
Leave the door open and insert the
plastic scraper in the appropriate
seating at the bottom centre, plac-
ing a basin underneath to collect the
defrost water.
In order to speed up the defrost-
ing process, place a pot of warm
water in the freezer compart-
ment. In addition, remove pieces
of ice that break away before de-
frosting is complete.
4.
When defrosting is completed, dry
the interior thoroughly and keep the
scraper for future use.
5.
Switch on the appliance.
6.
Turn the Temperature Regulator to
the << -18 °C >> position and leave
to run for at least 4 hours in quick
freeze mode.
7.
After 4 hours reload the previously
removed food into the compart-
ments.
WARNING!
Never use sharp metal tools to
scrape off frost from the evapo-
rator as you could damage it.
Do not use a mechanical device
or any artificial means to speed
up the thawing process other
than those recommended by the
manufacturer.
A temperature rise of the frozen
food packs, during defrosting,
may shorten their safe storage
life.
6.3 Periods of non-operation
When the appliance is not in use for
long periods, take the following precau-
tions:
1.
disconnect the appliance from elec-
tricity supply
ENGLISH
25
Publicité
