Publicité
Warning !
You must observe the following basic safety in order to avoid electric shock,
injury and fire hazard when using power tools. Read and follow these instructions before
you start using a tool. These instructions must be kept secure.
• The product should never be used near a hazardous area.
• Do not let the wire in contact with a body part.
• Use only extension cords intended for use in the workspace.
• Do not force the unit to perform inadequate work, such as coarse sanding, brushing,
etc. Otherwise, this may cause danger and damage.
• Use only identical replacement parts when servicing.
Otherwise, safe operation can not be guaranteed.
• Whether the authorized accessories speed must be at least the same as the maximum
speed of the device, otherwise they may break or crack if the operating speed exceeds
the speed limit of the camera.
• Do not use damaged accessories. Before use, always check that the accessories are
chipped or cracked. For example, to the sanding pad, please verify that the support
plate is not cracked. Make sure everyone is out of the range of rotation of the device
and operate The set at maximum speed for one minute, in order to fully test the
accessories.
• Do not place appliance until it has completely stopped. Otherwise, you will lose control
of the unit.
• Clean the orifice discharge device.
• During use, check the unit firmly with both hands in order to ensure safe operation.
• During sanding, do not use too abrasive. When choosing a sanding disk, observe the
manufacturer's specifications. Sandpaper beyond the sanding block is a risk of cuts and
injuries and entrapment.
• The set may be connected to one extension tube to the maximum.
• You should always wear gloves and industrial safety goggles when using the sander
drywall.
• Wearing tight-fitting clothing is mandatory.
• Always consider the reactions of torque.
• Wear a face shield to protect against hazardous dust and choose a suitable vacuum
cleaner.
Using drywall sander :
Before adjusting, repairing or servicing the machine, you should always put the switch in
the off position and disconnect the power cord magnetization sector !
Before first use :
• Check the nominal frequency of the power supply matches the information on the
nameplate.
• Before using the tool, read the manual carefully.
115159-4-Manual-G.indd 11
Precautions when using a drywall sander
EN :
20/05/15 17:02:28
Publicité
