CASO DESIGN Coffee Taste&Style Thermo Mode D'emploi page 32

Prog: Setting the clock and TIMER
Press Prog button once: Set the clock with H and Min
Press Prog button twice: Set the Timer with H and Min
Mode: Setting of the strength of the flavour of the brewed coffee (
strong).
13.2 Before using your device for the first time
Operate the device with only 1,2 L itres of water (without paper filter and without coffee
ground), as described in "quick start". Clean the device afterwards.
13.3 Setting the clock
Plug in the device. Press Prog button and CLOCK lights up.
Use the H button to set the hours and the Min button to set the minutes.
The setting is validated automatically.
13.4 Making Coffee
Warning
► Warning symbol: hot steam.
► Caution hot steam can escape at device. Risk of burns.
13.4.1 Preparations
Fill desired quantity of water into the watertank.
Check that filterholder is placed.
Insert the permanent filter into the filterholder or fold the bottom of a paper filter with 1x4
size and insert it into the filter holder. Fill desired amount of ground coffee into the filter.
► Do not fill to much ground coffee into the filter,otherwise the coffee grounds could
overflow.
Close the lid of the device. Place the insulated jug
stop.
Plug in the mains plug.
13.4.2 Selection of strength of flavour
With Mode button you can select desired strength of flavour of the brewed coffee (
medium,
ground. The selected strength of flavour will be saved.
13.4.3 Quick start
► Rinse the insulated jug with warm water before use.
Please note
strong . The flavour depends on the swelling time of the coffee
)
Please note
mild,
on the warming plate below the drip
medium
mild,
32