MO-EL TURBILED Emploi Et Entretien page 9

Problems due to transport a/o accidental falls
if the fan does not turn or is in contact with external bodywork, or
if lamps won't turn on disconnect the equipment and send it to a
service centre.
POSITIONING
It is advisable to place the product in dim light or in any case far from
light sources so that the light of the LEDs is more evident for insects.
The device can be fixed to the wall with the included support:
• Drill 2 holes in the wall at a distance of 10cm from each other and
insert the plugs (not included). Fig. 2-A
• Screw the wall mount with 2 screws (not included). Fig. 2 A-B
• Move the product closer, making sure that the grooves on the
wall bracket coincide with those on the bracket attached to the
product. Fig. 2 C-D-E
Remove the lower cylinder from the product if it is installed at a height
greater than 1.5m, to prevent it from falling due to accidental knocks.
The product can also be fixed on support 4471 (not included).
INSTRUCTIONS FOR USE
The equipment is designed for the continuous function, it capture
and collect the insects in a sack where they are dehydrated by the
air circulation.
The appliance 806 is equipped with a selector to activate the heating
function which helps the product to reach a temperature more similar
to that of a living being so as to better attract insects.
(806-80601) - By placing the switch in position I, the LEDs and the
suction fan will turn on.
(806) - Bringing the switch to position II will also activate the heating
function.
The only needed operation is the collecting sack emptying.
9