Ancona AN-1282 Instructions D'utilisateur page 10

Installations ( refer to page 4 for parts):
NOTE: Use threaded drywall anchors only when
mounting the hood on sheet rock. Mounting the hood
on wall studs or lumbars is highly recommended.
For consumer safety reasons, mounting screws and anchors have not been supplied with this
range hood. Different wall and cabinetry construction methods require speciÿc types of screws
and wall anchors. Please consult your installation specialist regarding the best type of mounting
screws and wall anchors to suit your home's construction.
Step 1: Top venting using 6" round damper:
• Fix the damper flap into the damper hole on top of
the range hood motor box(See Figure #1)
• Connect duct work to damper.
Use Duct Tape to ensure joint is sealed and air tight.
•
Step 2 : Attaching the unit to the wall
• Mark or drill a small hole on the mounting position according to the dimensions on the following drawings.
• Insert suitable screws into the holes.
• Hang the range hood onto the screws.
• Atach the ducting to the top round 6" damper and exhaust outdoors.
• The following drawings show the mounting dimensions of the 30" (750mm) width and the 36" (900mm) width.
Fig # 2
INSTALLATION:
Fig # 1
g # 4
10
g # 4