HP Deskjet F4100 Guide D'utilisation page 8

Chapter 1
(continued)
Light status
The Resume light is blinking.
The Check Print Cartridge light is
blinking.
The On, Resume, and Check Print
Cartridge lights are blinking.
All lights are blinking.
Load originals for scanning and copying
You can load many different types and sizes of paper in the HP All-in-One, including letter
or A4 paper, photo paper, transparencies, and envelopes.
For information about loading full-size paper, see the Setup Guide. For information about
loading other paper sizes, see the onscreen Help.
To load an original on the glass
1. Lift the lid on the HP All-in-One.
2. Place your original with the side you want to copy or scan face down on the left front
corner of the glass.
TIP:
object on the glass.
8 HP Deskjet F4100 All-in-One series
What it means
•
The HP All-in-One is out of paper.
• The HP All-in-One has a paper jam.
• The paper size setting in the copy software does not match the paper
size detected in the input tray.
• The print cartridge door is open.
• The print cartridges are missing or not seated correctly.
• The tape was not removed from the print cartridge.
• The print cartridge is not intended for use in this HP All-in-One.
• The print cartridge might be defective.
NOTE: Your printer might be packaged with only a tri-color print
cartridge.
Scanner failure.
Turn off the HP All-in-One, then turn it on again. If the problem persists,
contact HP Support.
The HP All-in-One has a fatal error.
1. Turn the HP All-in-One off.
2. Unplug the power cord.
3. Wait a minute, then plug the power cord back in.
4. Turn the HP All-in-One back on.
If the problem persists, contact HP Support.
To get the correct copy size, make sure that there is no tape or other foreign