Andis RACD Mode D'emploi page 5

Before starting clipper remove blade guard. Plug cord into electrical outlet, operate
at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start clipper
move switch button to "ON" position, to stop, move switch button back to original
position. After using your Andis clipper, rewrap cord and store in a safe place.
BLADE SETS
(Contents may vary by kit)
Your Andis clipper comes with a Size 10 blade (on clipper) and an additional
Size 7FC blade. A Size 4FC blade is also available for purchase (Figure A). The blade
size is indicated on the blade set. Use the clipping guide in this manual to find the
approximate length of cut for each blade set.
REMOVING BLADE SET
To remove blade set, first make sure your clipper motor is switched "OFF". Push
blade release button on top of clipper (Figure B). After the blade releases from the
clipper, slide it off the blade hinge (Figure C). NOTE: Hair may accumulate in the
front cavity of the housing under the blade. If this happens, you can clean out the
hair by brushing out the cavity with a small brush or an old toothbrush while the
blade is off the clipper.
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper (Figure C). Push the blade toward the clipper to lock into position.
USING THE ATTACHMENT COMBS
You can set the blades for a longer cut by using any of the attachment combs made
for your Andis clipper. The combs mount easily; simply slip the cutter blade teeth
into comb and snap the comb down (Figures D & E). To remove, simply snap off.
These attachment combs guide hair into the blades and give you precise control of
hair lengths. The length of trim is indicated on the attachment comb. Use the chart
to find the approximate lengths of cut. Different blade angles in relation to the skin,
thickness and texture of the hair will vary the cutting length.
USER MAINTENANCE
The internal mechanism of your trimmer has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station. To contact Andis directly, please call our Customer
Support Team at 1-800-558-9441 or email us at support@andisco.com.
5