Io-Link; Maintenance, Repair, Disposal - Rechner Sensors EasyTeach IO-Link Notice D'utilisation

Les langues disponibles

IO-Link

If the sensor is equipped with an IO-Link interface, you can use this interface to read out and set various

sensor values and parameters. To use the sensor in IO-Link mode, you need an module with IO-Link

function (IO-Link Master). Setting via EasyTeach is not possible during IO-Link communication.

Further information on IO-Link and the IODDS required for setting up the IO-Link sensor can be found at:

https://www.rechner-sensors.com/dokumentation/io-link

• Maintenance for this device is not necessary when used as intended.

• It is not possible to repair the device. If you have any problems, please contact directly your customer service.

• Please dispose of the device in a way that is environmentally friendly according to the national regulations

Table des Matières