Setting Up Operations; Overspeed Governor; Tension Weight With Counterweight - PFB LK200 Notice D'utilisation Et D'entretien

3

SETTING UP OPERATIONS

3.1

OVERSPEED GOVERNOR

The safety switch of the overspeed governor has already been set in the factory. Its position is fixed with
sealing-wax and it cannot be modified.
The setting up of the safety switch on the overspeed governor is not necessary.
3.2 TENSION WEIGHT WITH COUNTERWEIGHT (EN 81)
a) guide rail mounted tension pulley with horizontal or vertical counterweight:
Shift the mounting clamp of the tension weight with counterweight in such a way that the safety switch does not
●
become operative (Fig. 1 and Fig. 2, Pos. 1).
At the same time take into consideration the stretching of the rope!
On the safety switch adjust the connecting position on the slots in the vertical direction
●
(Fig.1 and Fig.2, Pos.2).
After the assembly, release the tension rope and check the control function by moving the tension arm. Then
●
fix the position with sealing-wax or similar.
After the insertion, the tripping pin of the safety switch must be reset by hand in the starting position
●
b) pit mounted tension pulley with vertical counterweight:
Move the mounting plate of the safety switch in the vertical direction (Fig. 3 – Pos. 1) in such a way that the
●
switch does not activate.
On the switch, adjust the horizontal connecting position on the slots (Fig.3 – Pos. 2).
●
After the assembly, release the overspeed governor rope and check the control function by moving the
●
counterweight slowly downwards on the guide rail and paying close attention. Then fix the position with sealing
wax or similar.
Following the insertion, the tripping pin of the safety switch must be reset in the starting position.
●
46
Fig. 1
Fig. 3
Fig. 2