Switching On And Off Your Midland Btx2 Pro; Operative "Mode - Midland BTX2 PRO Guide D'utilisation

left side of the helmet.
If neccesary, you can use also the rubber plate in order to have more grip for the screw
clamp. Just use the two short screw to fix the rubber plate on the slide-in mount and
tighten the screw plate again.
Fitting and removing your Midland BTX2 PRO
The BTX2 PRO can be easily fitted onto the helmet by sliding it downwards on the sliding
mounting kit. BTX2 PRO is maintained in position thanks to the fixing clip located on the
upper section (A). To detach the BTX2 PRO, simply press the fixing clip and push the
unit upwards.
Lock
www.midlandeurope.com
Rubber plate
Unlock
A

Switching ON and OFF your Midland BTX2 PRO

Switching the unit on:
Press and hold "Middle" button for approximately 3 seconds until the BLUE indicator
lights.
Switching the unit off:
Press and hold both "Middle" and "Backward" buttons together for approximately 3 se-
conds until the RED indicator flashes 3 times, thus lessening the chances that you might
turn off the unit accidentally (especially whilst wearing gloves).

Operative "mode"

The BTX2 PRO can operate in three main "mode": Intercom, Phone and FM Radio.
The 3 multi function buttons can have different functionality depending on which mode
the unit is at that moment.
› In "Intercom mode" the three buttons let you manage the Intercom communications
between driver and passenger or bike to bike.
› In "Phone mode" you can manage your Bluetooth mobile phone to place/answer a
phone call or to listen to the music or GPS App. announcement (in stereo mode).
Please use your phone responsibly and safely.
› In "FM Radio mode" you can listen to your favourite radio station in stereo, seek for a
specific radio station and save it (6 memories are available).
You can switch (toggle) from one mode to the other simply pressing the Middle button
for 3 seconds. A voice announcement will tell in which mode you are on.
The toggle sequence is the following:
› Intercom mode (if another unit has been paired)
› FM Radio
› Phone mode (if a phone has been paired)
Every time you turn on the unit, the default mode is the last used mode.
The Intercom mode and Phone mode are avalaible only if it was previously paired to
another unit or to a phone.
If you need to know in which mode the unit currently is, just press the "Volume + " and
"Volume –" buttons together. A voice announcement will tell you the current mode.
21