Makita 6936FD Manuel D'instruction page 7

1
Insert both ends, one by one, of the hook into the
grooves in the tool housing.
1
Keeping the hook in this position, rotate it upwards to the
angle 90°and push both ends fully in the direction of
arrow as shown in the figure.
90
007035
1. Hooking ends
007036
1. Groove in the
housing
007037
007038
007039
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
.
N m
(ft.lbs)
M14(9/16")
80
(58)
M12
60
(43)
40
M10 (3/8")
(29)
M8(5/16")
20
(14)
0 1.0
Fastening time
.
N m
High tensile bolt
(ft.lbs)
120
(86)
100
(72)
80
(58)
60
(43)
M8(5/16")
40
(29)
20
(14)
0 1.0
Fastening time
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
NOTE:
• Use the proper bit for the head of the screw/bolt
that you wish to use.
• When fastening screw M8 or smaller, carefully
adjust pressure on the switch trigger so that the
screw is not damaged.
• Hold the tool pointed straight at the screw.
7
004999
(1/2")
M14(9/16")
M12 (1/2")
M10 (3/8")
M8(5/16")
2.0 3.0
005000
M12(1/2")
M12(1/2")
M10(3/8")
M10(3/8")
M8(5/16")
2.0 3.0