Falcon Toledo XT Instructions D'utilisation Et D'installation page 52

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
21. To Remove an Oven fan Element
Disconnect from electricity supply.
Pull the unit forward to access the cover boxes at the rear
of the appliance. Remove the fi xings that secure the cover
and lift it clear. Undo the terminal connections noting their
positions. Remove the inner back as detailed in Section 22.
Remove the fi xings that secure the element within the oven
and lift the element away carefully. Fit the replacement
element and re-assemble parts in reverse order. Check that
the oven operates correctly.
22. To Remove the LH Oven Bottom and Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear
of the unit. Remove the fi xings that secure the cover and lift
it clear.
Remove the 2 screws 'A' and allow the plate to drop down.
Remove the 2 screws B, lower the upper plate and remove
through the slot in the cooker back.
Undo the terminal connections, noting their positions.
Remove the element fi xings and withdraw element. Replace
the element and re-assemble parts in reverse order.
Top Element
Open the LH oven door and undo the fi xings that secure the
heat shield. Remove the top element bracket fi xings and
withdraw element. Replace the element and re-assemble
parts in reverse order. Check that the oven operates
satisfactorily.
23. To Change Warmer Neon
Remove RH hotplate (see 2). Carefully place hotplate upside
down on a suitable fl at surface. Remove 2 screws holding
neon bracket to Warmer frame. Fit new neon and bracket
assembly.
Reassemble in reverse order and check for correct operation.
24. To Change Warmer
Remove RH hotplate, see 2. Fit new RH hotplate and
reassemble in reverse order.
Check High burner and Warmer operation is satisfactory.
52